TIBCO Adapter for Files (FA)6.1.0 subscriber appends an octal character (032)(Octal value=032, Hexadecimal value=1A) at the end of the file when using SFT mode and 'End of Line' as "Unicode".
Article ID: KB0088356
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks Plug-in for Files for Unix and Windows | - |
| Not Applicable | - |
Description
Description:
When using TIBCO Adapter for Files (FA) 6.1.0, the file adapter subscriber appends an octal character (032)(Octal value=032, Hexadecimal value=1A) at the end of the file when using SFT mode and 'End of Line' as "Unicode".
Symptoms:
When using TIBCO Adapter for Files (FA) 6.1.0, the file adapter subscriber appends an octal character (032)(Octal value=032, Hexadecimal value=1A) at the end of the file when using SFT mode and 'End of Line' as "Unicode".
Cause:
This issue can be seen when using FA 6.1.0, when 'End of Line' is set as "Unicode" if we flip the file adapter from SFT to Record mode. When we revert back from Record to SFT mode, the end of line does not restore back to "system". If we use 'SFT' supported 'End of Line' as "System", then this issue is not seen.
When using TIBCO Adapter for Files (FA) 6.1.0, the file adapter subscriber appends an octal character (032)(Octal value=032, Hexadecimal value=1A) at the end of the file when using SFT mode and 'End of Line' as "Unicode".
Symptoms:
When using TIBCO Adapter for Files (FA) 6.1.0, the file adapter subscriber appends an octal character (032)(Octal value=032, Hexadecimal value=1A) at the end of the file when using SFT mode and 'End of Line' as "Unicode".
Cause:
This issue can be seen when using FA 6.1.0, when 'End of Line' is set as "Unicode" if we flip the file adapter from SFT to Record mode. When we revert back from Record to SFT mode, the end of line does not restore back to "system". If we use 'SFT' supported 'End of Line' as "System", then this issue is not seen.
Issue/Introduction
TIBCO Adapter for Files (FA)6.1.0 subscriber appends an octal character (032)(Octal value=032, Hexadecimal value=1A) at the end of the file when using SFT mode and 'End of Line' as "Unicode".
Resolution
This issue has been fixed in FA 6.1.0 Hotfix-04.
Feedback
Yes
No
Powered by
