Missing list of process starter and active processes on the secondary application of the fault tolerance application.
Article ID: KB0087976
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks | - |
| Not Applicable | - |
Description
Resolution:
Description
=========
Deploy the engine in fault tolerance mode. The secondary engine is in standby status. Unable to find any process starter or active process on this engine.
Environment
==========
All
Resolution
=========
This is normal behavior. When the engine is in stand by, it does not show any process starter or active process. Only when it becomes active, the process starter and active process be shown.
Description
=========
Deploy the engine in fault tolerance mode. The secondary engine is in standby status. Unable to find any process starter or active process on this engine.
Environment
==========
All
Resolution
=========
This is normal behavior. When the engine is in stand by, it does not show any process starter or active process. Only when it becomes active, the process starter and active process be shown.
Issue/Introduction
Missing list of process starter and active processes on the secondary application of the fault tolerance application.
Feedback
Yes
No
Powered by
