Correction to the “TIBCO ActiveMatrix BPM Installation and Configuration” guide - Installing and Configuring a High Availability, Fault Tolerant ActiveMatrix BPM System
Article ID: KB0090712
Updated On:
| Products | Versions |
|---|---|
| TIBCO BPM Enterprise (formerly TIBCO ActiveMatrix BPM) | - |
| Not Applicable | - |
Description
Description:
Description:
============
There is an error in the document “TIBCO ActiveMatrix(R) BPM Installation and Configuration, Software release 2.0, November 2012".
In Chapter 4 - Installing and Configuring a High Availability, Fault Tolerant ActiveMatrix BPM System -> Task 4: Remote Machine - Install ActiveMatrix BPM Software -> step 4, when completing the Installation Profile Selection screen, the document states that you should select the “Remote machine” profile.
This is incorrect. You should select the “Primary machine” profile.
Environment:
==========
o TIBCO ActiveMatrix BPM 2.0.x (+ Hotfixes).
Description:
============
There is an error in the document “TIBCO ActiveMatrix(R) BPM Installation and Configuration, Software release 2.0, November 2012".
In Chapter 4 - Installing and Configuring a High Availability, Fault Tolerant ActiveMatrix BPM System -> Task 4: Remote Machine - Install ActiveMatrix BPM Software -> step 4, when completing the Installation Profile Selection screen, the document states that you should select the “Remote machine” profile.
This is incorrect. You should select the “Primary machine” profile.
Environment:
==========
o TIBCO ActiveMatrix BPM 2.0.x (+ Hotfixes).
Issue/Introduction
Correction to the “TIBCO ActiveMatrix BPM Installation and Configuration” guide - Installing and Configuring a High Availability, Fault Tolerant ActiveMatrix BPM System
Feedback
Yes
No
Powered by
