Populating JMSReplyTo property of Outgoing JMS message from BusinessEvents.
Article ID: KB0090919
Updated On:
| Products | Versions |
|---|---|
| TIBCO BusinessEvents Enterprise Edition | - |
| Not Applicable | - |
Description
Resolution:
Description:
===========
Unable to populate JMSReplyTo property of Outgoing JMS message from BusinessEvents.
Environment:
===========
TIBCO BusinessEvents 3.0.1
All Operating Systems
Resolution:
========
If you create a property which starts with JMS, such as JMSReplyTo of outgoing JMS message from BusinessEvents, it will be ignored by BusinessEvents engine. This property cannot hit the receiver side. You only can set the JMS property which is listed in the BusinessEvents document.
This has been fix in BusinessEvents 3.0.1, Hotfix 3
Description:
===========
Unable to populate JMSReplyTo property of Outgoing JMS message from BusinessEvents.
Environment:
===========
TIBCO BusinessEvents 3.0.1
All Operating Systems
Resolution:
========
If you create a property which starts with JMS, such as JMSReplyTo of outgoing JMS message from BusinessEvents, it will be ignored by BusinessEvents engine. This property cannot hit the receiver side. You only can set the JMS property which is listed in the BusinessEvents document.
This has been fix in BusinessEvents 3.0.1, Hotfix 3
Issue/Introduction
Populating JMSReplyTo property of Outgoing JMS message from BusinessEvents.
Feedback
Yes
No
Powered by
