Resolution:
Description:
===========
When using EMS as domain transport and are using FT mode, the RV related properties are hard coded to the default value as:
Bus.Default.Service=7500
Bus.Default.Daemon=tcp\:7500
Bus.Default.Network=

Environment:
==========
All

Symptoms:
==========
Even if configured these parameters in bwengine.tra or beengine.xml file these values are not transported into the application’s tra file.

Cause:
==========
By default the Fault Tolerant BW engines communicate through heartbeat messages using the default RV parameters (7500). Normally properties specified in bwengine.tra will be copied to application .tra at deployment. But the FT transport parameters (Bus.Defult.*) are a bit different from others. Participators in a FT group need to have the same transport parameters to communicate with each other. There is a possibility that bwengine.tra files on different machines are not synchronized with the same configuration; so, to keep application integrity, when deploy in FT mode, the transport parameters written to an application .tra file would always be the default values and the user needs to manually modify them.

Resolution:
==========
Manual modify the parameters in the application’s tra file.

Bus.Default.Daemon and Bus.Default.Service are not consistent with domain.