If the IP Address of a box is changed, what should be done for RV daemon and RV client?
Article ID: KB0086457
Updated On:
| Products | Versions |
|---|---|
| TIBCO Rendezvous | - |
| Not Applicable | - |
Description
Resolution:
Description:
==========
1). For RV clients:
- If the daemon box IP address has been changed, you should verify the network and daemon for all client transport parameters. If the IP address is used in the rvd command line and it is changed, you should modify it. All affected RV clients should be restarted.
2). For rvd:
- If “-listen <ip address> is used in the rvd command line and it is changed, it should be modified. The rvd daemon should be restarted.
3). For rvrd:
- Verify the local network and neighbor configuration. If the IP addresses are used and changed, the should be modified.
- If “-listen <ip address> is used in the rvrd command line, and it is changed, it should be modified The rvrd daemon should be restarted.
Description:
==========
1). For RV clients:
- If the daemon box IP address has been changed, you should verify the network and daemon for all client transport parameters. If the IP address is used in the rvd command line and it is changed, you should modify it. All affected RV clients should be restarted.
2). For rvd:
- If “-listen <ip address> is used in the rvd command line and it is changed, it should be modified. The rvd daemon should be restarted.
3). For rvrd:
- Verify the local network and neighbor configuration. If the IP addresses are used and changed, the should be modified.
- If “-listen <ip address> is used in the rvrd command line, and it is changed, it should be modified The rvrd daemon should be restarted.
Issue/Introduction
If the IP Address of a box is changed, what should be done for RV daemon and RV client?
Feedback
Yes
No
Powered by
