Why do the custom methods disappeared after restarting the adapter instance in admin while using TIBCO® Adapter SDK 5.7?
Article ID: KB0087559
Updated On:
| Products | Versions |
|---|---|
| TIBCO Adapter SDK | - |
| Not Applicable | - |
Description
Resolution:
Description
===================================================
In SDK adapter 5.7, the custom method disappear after restarting the adapter instance in admin.
Symptoms:
========
To reproduce the issue, refer to steps below..
1). Enable all the custom microagent for adapter by setting below properties to "on" in the tra file.
XXX.perfMon = ON
XXX.addCustomHawkMethodsToClassMAgent = ON
2). Restart the adapter instance after setting properties above.
3). Restart the Hawk agent. The custom methods will be seen in admin.
4). Restart the adapter instance. The custom methods will no longer be viewable.
Resolution:
==========
To make sure the custom methods not disappeared after restarting the adapter instance in admin, configure the tibco.dedicatedHawkThread to "OFF" in the adapter tra file.
The default value of the tibco.dedicatedHawkThread is "on". If the tibco.dedicatedHawkThread is set to "on", one dedicated Hawk Thread will be created for processing the Hawk heart and describe methods. Otherwise, the Hawk heart and describe methods will be processed by the main thread.
Description
===================================================
In SDK adapter 5.7, the custom method disappear after restarting the adapter instance in admin.
Symptoms:
========
To reproduce the issue, refer to steps below..
1). Enable all the custom microagent for adapter by setting below properties to "on" in the tra file.
XXX.perfMon = ON
XXX.addCustomHawkMethodsToClassMAgent = ON
2). Restart the adapter instance after setting properties above.
3). Restart the Hawk agent. The custom methods will be seen in admin.
4). Restart the adapter instance. The custom methods will no longer be viewable.
Resolution:
==========
To make sure the custom methods not disappeared after restarting the adapter instance in admin, configure the tibco.dedicatedHawkThread to "OFF" in the adapter tra file.
The default value of the tibco.dedicatedHawkThread is "on". If the tibco.dedicatedHawkThread is set to "on", one dedicated Hawk Thread will be created for processing the Hawk heart and describe methods. Otherwise, the Hawk heart and describe methods will be processed by the main thread.
Issue/Introduction
Why do the custom methods disappeared after restarting the adapter instance in admin while using TIBCO® Adapter SDK 5.7?
Feedback
Yes
No
Powered by
