For a standby BW engine, the method getAcitveProcessCount/GetProcesses times out.
Article ID: KB0089919
Updated On:
| Products | Versions |
|---|---|
| TIBCO Hawk | - |
| Not Applicable | - |
Description
Description:
When invoking Hawk method getAcitveProcessCount/GetProcesses over a standby BW engine, it times out.
Symptoms:
If the method is used in a rulebase and the engine goes to standby, there will be a NoValidDataSource alert.
Cause:
This is a known issue BW-8111. The method should return a value instead of time out.
When invoking Hawk method getAcitveProcessCount/GetProcesses over a standby BW engine, it times out.
Symptoms:
If the method is used in a rulebase and the engine goes to standby, there will be a NoValidDataSource alert.
Cause:
This is a known issue BW-8111. The method should return a value instead of time out.
Issue/Introduction
For a standby BW engine, the method getAcitveProcessCount/GetProcesses times out.
Resolution
If the method is used in a rulebase, as a workaround, another rulebase could be used to detect whether the engine is in standby and then load/unload the working rulebase.
Additional Information
http://jira.tibco.com/browse/BW-8111
Feedback
Yes
No
Powered by
