How to apply Hotfix in TIBCO BusinessWorks ProcessMonitor 3.0.0.x cluster setup.
Article ID: KB0093247
Updated On:
| Products | Versions |
|---|---|
| TIBCO BusinessWorks ProcessMonitor | - |
| Not Applicable | - |
Description
Description:
TIBCO BusinessWorks ProcessMonitor(BWPM) 3.0 has a built in load balancing feature. You can create BWPM setup with multiple nodes. When you want to apply a hotfix then there is need to apply a hotfix on each node, but database migration has to be done only once.
TIBCO BusinessWorks ProcessMonitor(BWPM) 3.0 has a built in load balancing feature. You can create BWPM setup with multiple nodes. When you want to apply a hotfix then there is need to apply a hotfix on each node, but database migration has to be done only once.
Issue/Introduction
How to apply Hotfix in TIBCO BusinessWorks ProcessMonitor 3.0.0.x cluster setup.
Resolution
When applying hotfix on TIBCO BusinessWorks ProcessMonitor(BWPM) 3.0.0 cluster setup, follow the steps below:
1). Stop both applications. Shutdown NODE1 and NODE2 (not just stopping data providers).
2). Apply the hotfix on all nodes.
3). Execute the migration on one node only.
4). Start the other applications.
It is important to note that the migration has to be done only once.
Additional Information
SR # 83 (https://support.integrationmatters.com/hc/en-us/requests/83?page=4 )
Feedback
Yes
No
Powered by
