Is it possible to activate DR for a single EMS instance in a EMSA DR setup?
Article ID: KB0093053
Updated On:
| Products | Versions |
|---|---|
| TIBCO Enterprise Message Service Appliance | - |
| Not Applicable | - |
Description
Resolution:
As per the current design of the EMSA Disaster recovery, we cannot failover a single instance from Production to a DR site. This is because the likelihood of failure of an instance alone is very low and would likely be due to configuration issues. Either a network outage or a disk related issue impacts both instances in the production site. We have to failover both Instances from Production to the DR site.
As per the current design of the EMSA Disaster recovery, we cannot failover a single instance from Production to a DR site. This is because the likelihood of failure of an instance alone is very low and would likely be due to configuration issues. Either a network outage or a disk related issue impacts both instances in the production site. We have to failover both Instances from Production to the DR site.
Issue/Introduction
Is it possible to activate DR for a single EMS instance in a EMSA DR setup?
Feedback
Yes
No
Powered by
