Timer configured to run once goes into a loop.
Article ID: KB0093040
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks | - |
| Not Applicable | - |
Description
Description:
When deployed, an application that is configured to use the Timer to run once goes in infinite loop.
Symptoms:
Timer activity configured to run once at some interval keeps on executing in a loop.
Cause:
This is a known issue with an existing JIRA BW-8476 in the case when both FlowLimit and MaxJobs is set to 1.
When deployed, an application that is configured to use the Timer to run once goes in infinite loop.
Symptoms:
Timer activity configured to run once at some interval keeps on executing in a loop.
Cause:
This is a known issue with an existing JIRA BW-8476 in the case when both FlowLimit and MaxJobs is set to 1.
Issue/Introduction
Timer configured to run once goes into a loop.
Resolution
Modify the FlowLimit as 2 with MaxJobs as 1. Usually, FlowLimit is configured as twice the size of Maxjobs.
Feedback
Yes
No
Powered by
