BC 3.5.0 Hotfix 6 is now available
Article ID: KB0105540
Updated On:
| Products | Versions |
|---|---|
| TIBCO BusinessConnect | - |
| Not Applicable | - |
Description
Description:
TIBCO BusinessConnect 3.5.0 Hotfix 6 is released. This hotfix is cumulative of prior hotfixes for this version. Listed below is a summary of updates. Please refer to the attached Readme for additional details on these and other cumulative fixes included in this Hotfix.
* At the time of this release, this hotfix has been tested for compatibility with the following protocol versions:
EDI 2.7.0 Hotfix1, 2.7.1 (to be released in May '04)
cXML 1.4.0
ebXML 1.3.0
SOAP 1.3.1
IMPORTANT NOTE: When tested with BCRN 2.8.0, a problem was uncovered with manual resend, please see LBN1-1UC2XT. This will be fixed in the next BC 3.5 hotfix. For this reason, we are recommending you use BC 3.5 HF4 if you are using BCRN 2.8.0.
If a protocol Hotfix is released subsequently, it will also contain updated compatibility information. We recommend you to check with TIBCO Support if you are not sure about protocol compatibility with this Hotfix.
[Hotfix 6]
* Known Issues - check the attached Readme.
Fixed issues:
Defect Id: 1-1J66D9
The DMZ server throws FESI exception when the HTTP event source is set to skip reading message, identified by the property "Config.WebEventSource.SkipReadMessageBody", "bc.dmz.skipcontent.download" property is set to true and if the incoming message size is greater than the threshold value, specified by the property "bc.dmz.skipContent.threshold".
Defect Id: 1-1J66DN
When bc.dmz.skipContent.download property is set to true and when the incoming message size is greater than the threshold value, specified by the property bc.dmz.skipContent.threshold, messages from the DMZ to interior BC was always published on the default RV parameters.
Defect Id: 1-1K4YO8
When DMZ is enabled with Email transport and "bc.dmz.email.skipContent.<standard name>" property is set to true, single bodypart attachments failed.
Defect Id: 1-1MB8DL
Shared secrets were not serializable during checkpointing. Note: This fix is for cXML only.
Defect Id: 1-1G15KI
BC-EDI: EDI with DMZ on the same machine in load balanced mode cannot process emails that are already in the inbox when BC starts
Defect Id: 1-1MB491
Message decryption skipped when a signed/encrypted message was received with no smime-type.
Defect Id: 1-1M8HA7
The BC X.509 sample server certificates were expiring on 2/27/04. Updated with new sample certificates.
Defect Id:1-1L4UBI
BP: After the BP 3.5.0 hotfix-5 install, the configserver throws a ServletException
Defect Id: 1-1L4UBW
BP: BP 3.5 hotfix 3,4,5 all create configserver\webapps\BusinessConnect directory
Defect Id: 1-1PTPUA
Fixed the fesi exception thrown when processing multipart/mixed message that contained large number of email attachments.
Defect Id: 1-11A5AL
Missing ae class attributes under EDI folder, after running exportCfg/importCfg.
TIBCO BusinessConnect 3.5.0 Hotfix 6 is released. This hotfix is cumulative of prior hotfixes for this version. Listed below is a summary of updates. Please refer to the attached Readme for additional details on these and other cumulative fixes included in this Hotfix.
* At the time of this release, this hotfix has been tested for compatibility with the following protocol versions:
EDI 2.7.0 Hotfix1, 2.7.1 (to be released in May '04)
cXML 1.4.0
ebXML 1.3.0
SOAP 1.3.1
IMPORTANT NOTE: When tested with BCRN 2.8.0, a problem was uncovered with manual resend, please see LBN1-1UC2XT. This will be fixed in the next BC 3.5 hotfix. For this reason, we are recommending you use BC 3.5 HF4 if you are using BCRN 2.8.0.
If a protocol Hotfix is released subsequently, it will also contain updated compatibility information. We recommend you to check with TIBCO Support if you are not sure about protocol compatibility with this Hotfix.
[Hotfix 6]
* Known Issues - check the attached Readme.
Fixed issues:
Defect Id: 1-1J66D9
The DMZ server throws FESI exception when the HTTP event source is set to skip reading message, identified by the property "Config.WebEventSource.SkipReadMessageBody", "bc.dmz.skipcontent.download" property is set to true and if the incoming message size is greater than the threshold value, specified by the property "bc.dmz.skipContent.threshold".
Defect Id: 1-1J66DN
When bc.dmz.skipContent.download property is set to true and when the incoming message size is greater than the threshold value, specified by the property bc.dmz.skipContent.threshold, messages from the DMZ to interior BC was always published on the default RV parameters.
Defect Id: 1-1K4YO8
When DMZ is enabled with Email transport and "bc.dmz.email.skipContent.<standard name>" property is set to true, single bodypart attachments failed.
Defect Id: 1-1MB8DL
Shared secrets were not serializable during checkpointing. Note: This fix is for cXML only.
Defect Id: 1-1G15KI
BC-EDI: EDI with DMZ on the same machine in load balanced mode cannot process emails that are already in the inbox when BC starts
Defect Id: 1-1MB491
Message decryption skipped when a signed/encrypted message was received with no smime-type.
Defect Id: 1-1M8HA7
The BC X.509 sample server certificates were expiring on 2/27/04. Updated with new sample certificates.
Defect Id:1-1L4UBI
BP: After the BP 3.5.0 hotfix-5 install, the configserver throws a ServletException
Defect Id: 1-1L4UBW
BP: BP 3.5 hotfix 3,4,5 all create configserver\webapps\BusinessConnect directory
Defect Id: 1-1PTPUA
Fixed the fesi exception thrown when processing multipart/mixed message that contained large number of email attachments.
Defect Id: 1-11A5AL
Missing ae class attributes under EDI folder, after running exportCfg/importCfg.
Issue/Introduction
BC 3.5.0 Hotfix 6 is now available
Environment
Product: TIBCO BusinessConnect
Version: 3.5.0
OS:
--------------------
Attachments
Feedback
Yes
No
Powered by
