What is the use of CM component in Tethered mode on Mashery Local?
Article ID: KB0073953
Updated On:
| Products | Versions |
|---|---|
| TIBCO Cloud API Management - Local Edition | 5.x and above |
Description
CM component in Tethered setup is used as Cluster Manager vs Config Manager( Untethered setup), as configurations in tethered setup are done via the Control Center
Here are the doc chapters that mention this:
https://docs.tibco.com/pub/mash-local/5.3.0/doc/html/GUID-A4CA8676-0334-4FA3-9C1D-85E13F8D0608.html
https://docs.tibco.com/pub/mash-local/5.3.0/doc/html/GUID-748A7D7B-F8D2-410C-A180-2441FEEAD07B.html
Here are the doc chapters that mention this:
https://docs.tibco.com/pub/mash-local/5.3.0/doc/html/GUID-A4CA8676-0334-4FA3-9C1D-85E13F8D0608.html
https://docs.tibco.com/pub/mash-local/5.3.0/doc/html/GUID-748A7D7B-F8D2-410C-A180-2441FEEAD07B.html
Issue/Introduction
This article answer the above question.
Environment
All Supported Platforms
Resolution
The CM component also contains the clustermanager component and so is required for tethered setup.
clustermanager provides CLI-based utility to check cluster status, component status, identity/truststore management etc.
clustermanager provides CLI-based utility to check cluster status, component status, identity/truststore management etc.
Feedback
Yes
No
Powered by
