What trace level should be used to turn on the SAP JCo DEBUG trace however without dumping the content data

What trace level should be used to turn on the SAP JCo DEBUG trace however without dumping the content data

book

Article ID: KB0081553

calendar_today

Updated On:

Products Versions
TIBCO ActiveMatrix BusinessWorks Plug-in for SAP Solutions 7.x, 8.x

Description

In some cases the SAP JCo DEBUG trace is needed to be turned on in order to track the activities specific to a transaction id.
However the content data is not needed to be dumped into the JCo trace file in case the JCo trace file takes too much disk space.

Environment

All Supported Platforms

Resolution

In this case the trace level of SAP JCo should be assigned to value 5 (value range is 0 - 10) by setting the property jco.trace_level to 5.

 

Issue/Introduction

What trace level should be used to turn on the SAP JCo DEBUG trace however without dumping the content data

Additional Information

For more information about the trace content of each trace level (0 - 10), please refer to the link of SAP JCo Introduction below:
https://wiki.scn.sap.com/wiki/display/ASJAVA/SAP+JCo+Introduction